P/N GS-0009_Rev. 3 AKM, AK74, Krinkov, M85/M92 Barrel Disassembly & Assembly Tool
Price: $69.50 + $7.25 Shipping = $76.75 (Cash Price) Or $79.35 (PayPal Price)
This tool is designed to safely disassemble the components of the barrel from a cut-up or intact barrel assembly and is a combination of the GS-0001, GS-0009_Rev. 2, and the GS-0018. It can also be used to assemble the parts on a new or reclaimed barrel. It is a superior replacement for plain press plates and rails that are available elsewhere and allows the thin-walled barrel components to be moved without damage. The slot for the rear sight block is counterbored with a lip that fits the area just underneath the “ring”. Another slot is chamfered to clear the barrel fillet so the hinge block ring can fit in – tough because it resides very close to the breech block. It is manufactured from 5/8″-thick x 1 1/2″ wide x 9″ long AISI 1018 cold-drawn steel that is not heat-treated.
P/N GS-0018 AK74, Krinkov, M85, M92 Front Sight Plate
Price: $24.00 + $7.20 Shipping = $31.20 (Cash Price) Or $32.44 (PayPal Price)
This tool is designed to safely remove or hold the front sight block of the AK74 or Krinkov (M24,0 x 1,5 right-hand thread) or the gas/front sight block of the M85 or M92 (M26,0 x 1,5 left-hand thread). It is manufactured from 5/8″-thick x 1 1/2″ wide x 9″ long AISI 1018 cold-drawn steel that is not heat-treated.
P/N GS-0015-A Zastava & Bulgarian Receiver Pistol Grip Nut Bucking Bar
Price: $22.00 + $7.20 Shipping = $29.20 (Cash Price) Or $30.37 (PayPal Price)
The GS-0015 is a bucking block used to buck the rivets used to fasten the pistol grip nut found on Zastava milled receivers, Zastava stamped receivers, and Bulgarian milled receivers. NOTE! The GS-0015-A will not work on a Russian Type 3 since the pistol grip screw enters at a different angle.
This part is manufactured from AISI 1018 cold-drawn steel that is not heat-treated. It holds all three (03) rivets securely in order to form the heads on the inside of the receiver. It is supplied with a diameter M6 x 0,8 x 30,0mm socket-head cap screw to hold the assembly securely as the rivets are headed. Note – it can also be used to hold a receiver section from drilling the heads from old rivets.