P/N GS-0003-A, -B, -C Zastava (Yugoslavian) M72 RPK & M76 Barrel Assembly Toolset
Price: $55.00 (+ Applicable Shipping Costs & Fees)
NOTE! For Professional Assemblers Casehardened Plates Are Available For A $22.00 Upcharge
This tool is designed to safely assemble the components of the barrel from a cut-up or intact barrel assembly. Like the other tools it is a superior replacement for plain press plates and rails that are available elsewhere and allows the thin-walled barrel components to be moved without damage. This tool is designed solely for the Zastava RPK rifle barrel and does not work with the Romanian RPK barrel. Similar to the previous tool it is manufactured from 5/8″-thick x 1 1/2″ wide x 9″
long AISI 1018 cold-drawn steel that is not heat-treated.
Most of the Zastava RPK rifles used in the Balkan War have barrels that were worn beyond use and new barrels are now available from other suppliers. If you plan to disassemble a Zastava RPK barrel you will need these additional tools to safely remove the gas block – the P/N GS-0003-B split sleeve gas block support and the GS-0003-C support bar. These can be sold separately of course, but can be included with the GS-0003-A at a slight discount and for the same shipping cost. The complete toolset for the Zastava RPK is shown below with the split sleeve and support bar for supporting the gas block.
P/N GS-0006-N, -P, -Q, -R Zastava (Yugoslavian) M76 Barrel Assembly Tube Set
Price: $36.00 (+ Applicable Shipping Costs & Fees)
Note – these tubes do not weigh much but they take up a lot of space (long and narrow) and should be shipped with other tools to save a bit of money. These tubes are made from different internal diameter and wall thickness aircraft-grade AISI 4130 structural carbon steel and are merely cut-to-length and faced square. This tubing is expensive but very strong and straight. The tube sets now come with a brass pad for protection of the threaded muzzle of the 0.30″ caliber rifle.
P/N GS-0015 Zastava & Type 3 Pistol Grip Nut Bucking Bar
Price: $29.00 (+ Applicable Shipping Costs & Fees)
The GS-0015 is a bucking block used to buck the rivets used to fasten the pistol grip nut found on Type 3 milled receivers and all Zastava stamped and milled receivers. This part is manufactured from AISI 1018 cold-drawn steel that is not heat-treated. It holds all three (03) rivets securely in order to form the heads on the inside of the receiver. It is supplied with a diameter M6 x 0,8 x 30,0mm socket-head cap screw to hold the assembly securely as the rivets are headed. Note – it can also be used to hold a receiver section from drilling the heads from old rivets.
